TG
TraceGuard
Open Free GeoJSON Converter →

EUDR Cattle & Beef Geolocation Guide (HS 0102, ex 0201/0202, ex 0206 & 1602 50)

How single-point geolocation applies to cattle establishments—plus the Sept 2026 leather removal and Dec 2027 frozen tongue addition.

Reg. (EU) 2023/1115 & 2025/2650 TRACES NT GeoJSON Spec v1.5 Commodity & Exemptions

Section 1 · Why EU TRACES NT Rejects This & Regulatory Trigger

Cattle and beef supply chains operate differently from crop commodities under Regulation (EU) 2023/1115. While crops over 4 hectares require full polygons, Article 9(1)(d) permits single-point GPS coordinates for all establishments where cattle were born, raised, and kept. Meanwhile, Delegated Regulation (EU) 2026/2102 overhauled the Annex I cattle CN codes on September 18, 2026.

Under Regulation (EU) 2023/1115 (as amended by Regulation (EU) 2025/2650 and Delegated Regulation (EU) 2026/2102), compliance applies from December 30, 2026 for medium and large operators/traders (and all legacy EUTR timber) and June 30, 2027 for qualifying micro and small enterprises established by December 31, 2024. Ensuring strict TRACES NT Spec v1.5 geometry prevents Box 44 customs holds under TARIC document code C716.

Section 2 · Step-by-Step Technical & Statutory Checklist

Section 3 · Pre-Flight GeoJSON & Customs Box 44 Reference Table

Compliance Parameter EU TRACES NT Spec v1.5 / Statutory Requirement
CRS & Coordinate PrecisionEPSG:4326 (WGS-84), [longitude, latitude] order, >= 6 decimal places (~11 cm), 2D-only (no Z-altitude)
4.0000 ha Geometry RuleSingle 6-decimal GPS Point permitted for all cattle establishments (birth, raising, finishing)
Required Feature.propertiesProducerCountry ("CO"), ProducerName, ProductionPlace, unquoted numeric Area (ha, 4 decimals)
Topology & Payload CapsClosed CCW exterior ring (first == last), zero self-intersections, zero interior holes, <= 25 MB & <= 200 lines/DDS
HS / CN Scope & DeadlinesHS 0102 / ex 0201 / ex 0202 (Cattle & Beef) & CN ex 0206 21 00 (Frozen Tongues, Dec 2027) — 0102/0201/0202: Dec 30, 2026 (SMEs June 30, 2027) | ONLY CN ex 0206 21 00 phases in Dec 30, 2027 | Leather 4101, 4104, 4107 EXEMPT
Customs Box 44 TARIC CodeC716 (Primary Operator) or Y141 (SME transitional until June 29, 2027)
Reg. (EU) 2025/1093 Risk TierLow Risk (1% quota, Art. 13) | Standard Risk (3% quota, Art. 10–11) | High Risk (9% quota: BY, KP, MM, RU) — Art. 9 GeoJSON mandatory across all tiers; Art. 10/11 required unless 100% segregated Low-Risk origin
Valid EU TRACES NT Spec v1.5 GeoJSON Reference Example:
{
  "type": "FeatureCollection",
  "features": [
    {
      "type": "Feature",
      "properties": {
        "ProducerCountry": "CO",
        "ProducerName": "Verified Cooperative Lot 01",
        "ProductionPlace": "Verified Production Plot #1",
        "Area": 6.4215
      },
      "geometry": {
        "type": "Polygon",
        "coordinates": [
          [
            [
              -75.612345,
              2.192346
            ],
            [
              -75.609845,
              2.192346
            ],
            [
              -75.609845,
              2.194666
            ],
            [
              -75.612345,
              2.194666
            ],
            [
              -75.612345,
              2.192346
            ]
          ]
        ]
      }
    }
  ]
}

Section 4 · Technical FAQ (EU TRACES NT Spec v1.5 & 2026/2027 Compliance)

What is the primary compliance requirement covered in EUDR Cattle & Beef Geolocation Guide (HS 0102, ex 0201/0202, ex 0206 & 1602 50)?

Cattle and beef supply chains operate differently from crop commodities under Regulation (EU) 2023/1115. While crops over 4 hectares require full polygons, Article 9(1)(d) permits single-point GPS coordinates for all establishments where cattle were born, raised, and kept. Meanwhile, Delegated Regulation (EU) 2026/2102 overhauled the Annex I cattle CN codes on September 18, 2026.

What are the current EUDR enforcement deadlines and Reg. 2026/2102 scope rules?

Large and medium operators and traders (plus legacy EUTR timber products) must comply from December 30, 2026, while qualifying micro and small enterprises established by December 31, 2024 comply from June 30, 2027 (declaring TARIC Y141 until June 29, 2027). Delegated Regulation (EU) 2026/2102 removed cattle leather (4101, 4104, 4107), rubber belts/articles (ex 4010/4016), and soya sowing seeds (1201 10 00) on September 18, 2026 (following Chapter 49 books under Reg. 2025/2650), while phasing in instant coffee (2101 11 00), frozen cattle tongues (ex 0206 21 00), and palm-oil soap (ex 3401) on December 30, 2027.

How does TraceGuard EUDR validate and repair supplier coordinates privately?

TraceGuard EUDR parses Excel/CSV, KML, GPX, UTM, WKT, WhatsApp DMS, and GeoJSON 100% locally inside your browser's RAM—automatically closing open rings, untangling bowties (<= 2% area guard), stripping 3D Z-coordinates and holes, fixing quoted Area values, and normalizing 6-decimal precision without uploading confidential supplier lists to external servers.

Section 5 · Related EUDR Technical Guides (Internal Pillar Hub)

100% Client-Side Browser RAM · Zero Cloud Upload

Validate, Convert & Auto-Repair Supplier Files in 10 Seconds

100% Client-Side Browser RAM Processing (Zero Cloud Upload, Zero GDPR Supplier Exposure). Supports Excel/CSV, KML, GPX, UTM, WKT, WhatsApp DMS & GeoJSON.

Open Free GeoJSON Converter →